Top-rated independent heating and cooling across South Florida

Gas Furnace Repair in Melbourne, FL

If you smell gas, leave the house first, call 911 or your gas utility from outside, then call us. Once the property is safe, we handle gas furnace repair in Melbourne: ignitors that glow but never light, flame sensors coated after a season of sitting idle, pressure switches, blower motors that run long after the burners shut down. Florida furnaces work few hours a year, so problems show up on the first cool night. Call us or use the quote form and we will schedule the visit.

Call (888) 560-0120

You reach a person, not a menu
Open every day
The quote comes first, in writing

Taking calls until 5:00 PM ET

Every major brand, one numberCarrier Trane Lennox Goodman Rheem York American Standard Bryant

The symptoms that lead here in Melbourne

The heat blows cold air Failed ignition sequence, dirty flame sensor, or a burner that lights and drops out
It runs a few minutes then shuts off Short cycling from a restricted filter, blocked return, or a limit switch tripping on high heat
Nothing happens when I raise the temperature Thermostat wiring or settings, tripped breaker, blown low voltage fuse, or a dead control board

What a gas furnace repair visit involves

We start with what the furnace is actually doing. Short cycling, a blower that runs cold, a burner that never ignites and a unit that rumbles all point in different directions. A technician confirms the thermostat is calling for heat, then works through the ignition sequence, the safety controls and the airflow side. Gas and high voltage work stays with us. When we find the fault we explain it in plain language, tell you the parts involved, and get your approval before anything comes apart.

What we check on the unit

Common repairs on a gas furnace include the igniter, the flame sensor, the gas valve, the pressure switch, the limit switch, the inducer motor and the blower motor or its capacitor. We also look at the heat exchanger, the flue and the venting, because a cracked exchanger or a blocked flue is a safety matter and not a parts swap. Filters, return airflow and duct restrictions get checked too, since a starved furnace overheats and trips its own safety devices repeatedly.

How we decide repair is the right call

We weigh the age of the furnace, the condition of the heat exchanger, how often it has failed and whether parts are still available. A ten year old unit with one bad igniter is worth fixing. A furnace with a cracked heat exchanger or repeated control failures is a different conversation, and we will say so. In much of the region a gas furnace runs only a handful of weeks a year, so light use often makes a targeted repair the sensible choice.

Melbourne coverage

From Melbourne we also cover Palm Bay, West Melbourne, Indialantic, Satellite Beach, Melbourne Beach, Rockledge, Viera and Cocoa.

32925
32934
32935
32936
32937
32940
32941
32949

Related furnace repair work in Melbourne

All furnace repair in Melbourne → · Gas Furnace Repair across the region →

What you get on every job

Written quote before any work

Covering 119 cities across Florida.

A real person answers

Open 7 days, 8:00 AM to 5:00 PM ET.

All major brands serviced

Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.

Gas Furnace Repair in Melbourne — quick answers

My gas furnace turns on then shuts off after a minute. Why?

That pattern usually points to the flame sensor, a pressure switch or a limit switch tripping on overheat. A clogged filter or closed vents can cause it too. Change the filter, open the vents, then call us.

Is a gas smell ever safe to ignore?

No. Leave the building immediately, take everyone with you, and call 911 or your gas utility from outside. Do not flip switches or use the thermostat. Once the utility clears the property, call us to inspect and repair.

How soon can you get to my Melbourne home?

Call us with your address and what the system is doing, and we will give you a real window rather than a vague promise. No-cooling calls in Melbourne move to the front of the day during summer heat, and we schedule tune-ups and duct work for the cooler morning hours when we can.

How it works

Step 1
Tell us the symptom
Call or fill in the quote form and describe what changed. Warm air, short cycling, a breaker that keeps tripping, water stains on the ceiling. That detail helps us bring the right parts.
Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, refrigerant performance, airflow and the condensate line. We find the actual cause instead of swapping parts and hoping the problem stays away.
Step 3
You approve the repair
We explain what failed, what it takes to fix it, and how long the part is likely to last. Nothing gets replaced until you say go, and we test the system before leaving.

Call (888) 560-0120

A real person answers
Open 7 days
Written quote before work starts

Why homeowners call us

Built for the salt airCoastal Florida is hard on outdoor equipment. Coils corrode, contactors pit, fan motors seize early. We look for that damage during every air conditioning repair so a small failure does not take the whole system down.
Condensate lines we actually clearBy late summer, drain lines clog with algae and shut systems off on the float switch. We clear the line, check the pan and the safety switch, and show you what caused the backup.
Heating tooCold snaps still arrive. We do heating repair and heater repair on heat pumps, strip heat and furnace repair where homes have one, so the system works in January as well as August.
Plain talk about older systemsIf a repair makes sense, we repair it. If a unit is failing in ways that will keep costing you, we say that too and lay out the options. You decide, not us.
All major brands, gas & electricEvery major HVAC brand, gas and electric, handled by an independent crew.
Straight answersWhen a replacement beats a repair, we tell you, sometimes before we roll a truck.